Dimensional 1D Inspection

We are frequently asked to verify items that customers have purchased from suppliers who have not obtained ANSI/ISO/IEC 17025-05(E) Accreditation.  Customers can request the vendor to send the unit or units directly to us upon purchase and we certify that they meet the requirements outlined in the specific ASTM method(s).

Dimensional Standards ASTM D3767

  • Gage Block Sets
  • Go/No-Go Gage Sets
  • Plug or Pin Gage Sets
  • Feeler Gage Sets
    Inspections are performed on customer check standards such as dimensional gages, pin gage sets, feeler gage sets, rulers, scales, etc. The customer uses the check standards for intermediate checks on pedestal micrometers, hand micrometers, calipers, and fixtures such as heat deflection units, abraders, and Izod notching machines. This laboratory meets R205 – Specific Requirements: Calibration Laboratory Accreditation Program for the types of dimensional tests listed above and is considered equivalent to that of a calibration.

 

Flame Test Equipment ASTM E220, D5025, D5207 & ASTM D5025
Apparatus: Flame Test Equipment, Laboratory Burner, height gage, brass slug

  • Laboratory Burner - Burner Barrel and Orifice ( Inside Diameter, Length ); Needle Valve ( Angle (deg), Flat Top )
  • Flame Height Gage - Overall Height; Outside Diameter; Angle, Slug Mass.; Temperature
  • Thermal Sensor ( Brass Slugs ) Overall Height; Outside Diameter; Angle, Slug Mass.; Temperature

Quality Control

  • Fixtures & Jigs
    Apparatus: custom fixtures and jigs used by customer as quick reference guides.
    Dimensional measurement and verification to specific ASTM Method and/or Blueprint drawing requirements.


  • Injection Mold Plates
    Apparatus: Injection Mold Press
    Dimensional measurement and verification to specific ASTM Method and/or Blueprint drawing requirements.



The unit is certified to dimensional specifications outlined in the appropriate ASTM method, within full compliance with ANSI/ISO/IEC 17025-05(E), and utilizing NIST traceable standards and equipment.  Each unit receives a "Certificate of Verification" with "As Found" and "As Left" data and is ANSI/ISO/IEC 17025-2005(E) compliant. Riverview is a small company that customizes its service to the customer.  I am proud to say that our customers  love our certificates. We make them easy to read and understand, packing them with as much information as possible and ensuring they conform to ANSI/ISO/IEC 17025:2005(E), ANSI/NCSL Z540-1-1994 and A2LA requirements.


  • Send In Order Form

Please use the Form provided when sending anything in for service. The more information you provide is helpful in Riverview providing you the most efficient and accurate service.

  • Service Notices

We also track your equipment, 30 days prior to due dates we send out "Service Notices" to our customers.


We Accept

Certificate No. 1331-01 Calibration